ST1100: Metzeler Z6 v BS Exedra G547/G548 v BS T32

Also the front wheel got wider to 3.5"...
I thought so, but couldn't find the wheel sizes in the Honda service manual. Am I blind or did they not include that information in the general specifications section?
 
And BS have launched the Batlax T33 series... sizes are limited of course... o_O


No, still won't buy another motorcycle, they can lobby on this as much as they want... :cautious:
Well, at least they have the 'proper' size for the front for an ST1100 ABSII (and a ST1300).
And a 170/60 (ST1300 size) will 'work' on the rear if need be as I have used one of those before but then I run a BT020 Bias (proper size) on the back anyway. ;)


Looks like (assuming the above calculator is correct) 170 to 160 is .79mm (1/32 inches) in diameter and .39 mm (1/64 inches) in sidewall height.
The 160/60 makes the ST1100 stand up too straight on the side stand from my experience.
 
Last edited:
Well, at least they have the 'proper' size for the front for an ST1100 ABSII (and a ST1300).
And a 170/60 (ST1300 size) will 'work' on the rear if need be as I have used one of those before but then I run a BT020 Bias (proper size) on the back anyway. ;)


Looks like (assuming the above calculator is correct) 170 to 160 is .79mm (1/32 inches) in diameter and .39 mm (1/64 inches) in sidewall height.
The 160/60 makes the ST1100 stand up too straight on the side stand from my experience.
Except the speedometer is driven off the front wheel
 
Back
Top Bottom